Malamoo Beach Shelter Setup and Shade Tips

Quick answer

Set up your Malamoo 2 Hub Beach Shelter in under a minute by using the Rapid Hub frame and anchoring it properly in sand. Follow these steps to avoid common mistakes and maximize shade.

Step-by-step setup and shade tips

1. Choose your spot and orient the shelter: Find a flat area of sand away from the tide line. Face the open side away from the prevailing wind to reduce flapping. Lay the shelter flat on the ground with the hub facing up. A common mistake is setting up too close to the water, which can lead to wet gear when the tide comes in.
2. Pop open the Rapid Hub frame: Grasp the central hub and pull the legs outward evenly until the frame locks into place. The shelter should spring open in one smooth motion. If the frame does not lock, check that all legs are fully extended. Do not force it.
3. Secure the corners with sand anchors: Use sand bags or long sand stakes at each corner. Fill sand bags with dry sand and bury them slightly, or push stakes in at a 45-degree angle away from the shelter. Standard tent stakes will pull out in loose sand. Always use dedicated sand anchors.
4. Adjust the shade angle: If the shelter has adjustable poles, tilt the canopy to block the sun as it moves. Otherwise, reposition the entire shelter every few hours to stay in the shade. A common oversight is not adjusting for the sun's path, leaving you exposed later in the day.
5. Pack down and store: To pack, push the hub button or release the frame locks, then fold the legs together. Shake off sand before storing to prevent grit from damaging the fabric or zippers. Packing wet or sandy shelter can lead to mildew. Let it dry out if possible before storing.

Product facts

• Malamoo 2 Hub Beach Shelter: The Malamoo 2 Hub Beach Shelter has a UPF 50+ cover and a Rapid Hub frame that allows setup and pack down in seconds. This means you can get shade up fast when the sun gets intense, and the high UPF rating gives reliable protection from harmful UV rays.