Oztent Brace Extrusion Replacement Guide
By Oztent USA | Published: 2026-10-27
Category: How-to Guides
Learn how to diagnose and fix a damaged Oztent brace extrusion, including when to replace it with the No.7 part and screw kit.
Quick answer
If your Oztent brace extrusion is bent, cracked, or loose, replace it with the Oztent Replacement Parts - Brace Extrusion with Fittings No.7 (With Screw Kit) to restore stability and safe setup.
Why the brace extrusion matters
The brace extrusion is part of the folding frame that locks the tent walls into position. When it fails, the tent can sag, the frame may not lock securely, and setup becomes frustrating or unsafe.
Replacing it promptly prevents further stress on adjacent parts, such as hinges and corner fittings, which can also wear out when the frame is out of alignment.
Tools and preparation
You'll need a Phillips screwdriver (or the correct bit for the screws), a small pry tool or flathead screwdriver, and a clean, flat work area. The screw kit is included with the replacement part, so you don't need to source fasteners separately.
Before ordering, double-check the part number against the Oztent RV parts diagram to confirm the No.7 brace extrusion matches your tent model. If you're unsure, contact Oztent USA support with your tent's model and year.
Diagnosis and replacement steps
- Symptom: The tent wall sags on one side, the frame doesn't lock into place, or you see a visible bend, crack, or loose joint in the brace extrusion.
- Likely cause: The brace extrusion is bent or broken from impact, over-tensioning, or normal wear over time.
- Corrective action: Remove the old brace extrusion by unscrewing the fittings, then install the new No.7 brace extrusion with the included screw kit. Tighten the screws snugly but avoid over-torquing. After installation, test the fold and lock action to ensure the frame is secure.
- Stop or choose another option: If the frame shows damage beyond the brace extrusion—like bent hinge plates or cracked corner fittings—or if you're not comfortable with disassembly, contact Oztent USA support or a professional tent service for a full frame inspection. When in doubt, get expert help to avoid further damage.
Replacement part
- Oztent Replacement Parts - Brace Extrusion with Fittings No.7 (With Screw Kit): The Oztent Replacement Parts - Brace Extrusion with Fittings No.7 (With Screw Kit) is sold as an easy fix for broken Oztent RV parts. You get the extrusion, fittings, and screws in one package, so you can complete the repair without hunting for extra hardware.
Oztent Replacement Parts - Brace Extrusion with Fittings No.7 (With Screw Kit)
