Toilet Paper Holder Setup and Mounting Guide

Quick answer

Mount the OZTENT Toilet Paper Holder on a tent pole, tree, or RV awning rail using the built-in straps. The waterproof design keeps your toilet paper dry and clean.

Step-by-step setup and mounting guide

1. Choose your mounting spot: Select a tent pole, tree branch, RV awning rail, or any sturdy vertical or horizontal surface near your toilet area. The holder straps around poles up to about 2 inches in diameter. Avoid spots where the holder will be in direct rain runoff. Check that the surface is clean and dry before attaching the straps.
2. Thread the straps: Open the holder and loop the two adjustable straps around the chosen mount point. Feed the strap end through the buckle and pull snug—do not overtighten on a tent pole as it may bend the pole. The holder should hang level and not swing excessively. Leave a small gap between the holder and the mount to allow air circulation and prevent moisture buildup.
3. Insert the toilet paper roll: Open the waterproof zipper or flap (depending on your model) and place a standard toilet paper roll inside. Close the seal completely to keep out moisture and bugs. The holder is designed for single rolls; avoid overstuffing. Make sure the zipper is fully closed to maintain the waterproof seal.
4. Test accessibility and stability: Give the holder a gentle tug to confirm it is secure. Reach for the paper through the dispenser opening (if present) or unzip partially to grab the end. Adjust the position if the roll is hard to reach or if the holder swings too much. Position the holder at waist height for easiest access while seated or standing.

Product details

• Toilet Paper Holder: Waterproof and seam-sealed Your toilet paper stays dry even during rain or morning dew, so you never have wet and messy paper.