Foxwing Spar Hinge Replacement: Quick Steps
By Oztent USA | Published: 2026-10-25
Category: How-to Guides
Learn how to replace a broken Foxwing spar hinge with Oztent USA parts. Follow these steps to fix your awning arm without replacing the whole unit.
Quick answer
Replace a broken Foxwing spar hinge by ordering the correct Oztent USA replacement part and following a simple swap procedure. You can fix the arm without replacing the entire awning.
Why replace just the hinge?
A broken spar hinge often stops the Foxwing arm from folding or locking. Replacing only the hinge costs less than a new arm assembly and keeps your existing awning frame in service. The Foxwing Replacement Parts - Spar Hinge is designed for this exact fix, so you avoid compatibility guesswork.
What you need to know before starting
The replacement part fits most Foxwing models, but double-check the diagram on Oztent USA's product page to confirm you have the correct hinge variant. You will need a basic tool kit: a Phillips-head screwdriver, a small flathead for prying, and a clean work surface. The job takes about 20 minutes.
Common mistake: forcing the hinge pin out with pliers can damage the aluminum arm. Use gentle pressure and a punch tool if the pin is stuck.
How to replace the Foxwing spar hinge
- 1. Remove the old hinge: Open the Foxwing arm fully and locate the hinge pin. Use a flathead screwdriver to gently pry out the retaining clip, then tap the pin out with a small punch and hammer. Slide the broken hinge off the arm. If the pin won't move, apply penetrating oil and wait 5 minutes. Never use excessive force.
- 2. Install the new spar hinge: Align the replacement hinge with the arm holes. Insert the hinge pin from the opposite side and tap it flush. Reattach the retaining clip by pressing it into its groove with pliers. Check that the hinge pivots freely before closing the arm. A stiff hinge means the pin is not fully seated.
- 3. Test the arm movement: Fold and unfold the awning arm two or three times. Listen for grinding or binding. If the hinge catches, remove the pin and check for burrs on the arm. Lightly sand any rough edges with fine-grit sandpaper. A smooth movement confirms the replacement is correct. If the hinge still binds, recheck the part number against the diagram.
Product fact
- Foxwing Replacement Parts - Spar Hinge: Find a Retailer AN EASY FIX If you happen to break a part of your Foxwing then this is the place to be. Determine the part that needs replacing in the above diagram, order it and it will be at your door as soon as possible! Ordering the exact hinge part from the diagram avoids returns and ensures the replacement matches your Foxwing arm.
Foxwing Replacement Parts - Spar Hinge
