Foxwing Awning Brackets: Installation and Compatibility

Quick answer

Foxwing Awning Brackets let you attach your Foxwing awning to most vehicle racks and trays. This guide walks through the installation process, from gathering tools to final height adjustment.

Foxwing Awning Bracket installation steps

1. Gather tools and check your rack: You'll need a socket or wrench set (typically 10mm or 13mm), a tape measure, and a marker. Confirm your roof rack or tray has a compatible channel—Foxwing Awning Brackets work with most T-track, C-channel, and flat-plate systems. If your rack has an unusual profile, test-fit one bracket before proceeding. A common mistake is assuming all racks use the same bolt size. Check your channel width and bolt fit before starting.
2. Position the bracket on the rail: Slide the channel bolt into your rack's channel and place the bracket over it. Hand-tighten the nut just enough to hold the bracket in place but still allow movement. Repeat for the second bracket, spacing them according to your awning's mounting points—usually 36–48 inches apart. If the bracket won't slide easily, the channel bolt may be upside down. Flip it and try again.
3. Attach the awning to the brackets: With both brackets loosely mounted, lift the Foxwing awning and align its mounting feet with the bracket slots. Insert the provided bolts and hand-tighten them. Do not fully tighten yet—you'll need to adjust height and alignment in the next step. A common mistake is tightening the awning bolts first, which prevents you from adjusting bracket height later. Keep everything loose until alignment is set.
4. Set the awning height and level it: Use the height-adjusting slots on the brackets to raise or lower the awning. Aim for at least 6–8 inches of clearance above your vehicle's roofline so the awning can open fully without rubbing. Use a level or simply eyeball it from the side to ensure the awning sits parallel to the ground. If the awning tilts forward or backward, one bracket is higher than the other. Adjust each bracket independently until the awning is level.
5. Tighten all bolts and final check: Starting with the bracket-to-rack bolts, then the awning-to-bracket bolts, torque everything to a snug fit. Do not overtighten—powder-coated steel can chip if you use excessive force. Give the awning a gentle shake to confirm it's secure. If it moves, recheck bolt tightness. After driving a few miles, re-torque the bolts. Vibration can loosen them, especially on corrugated roads.

Product details

• Foxwing Awning Brackets: Multi-purpose bracket made from high-quality powder coated steel with channel bolts for most platforms. The powder coating resists rust and the channel bolts simplify attachment to common roof rack rails, so you can mount the awning securely without custom fabrication.