Foxwing Replacement Hinge Pin and Bush: Fitting Guide

By Oztent USA | Published: 2026-11-03

Category: 操作指南

Learn how to replace the Foxwing hinge pin and bush with a clear step-by-step process, plus the checkpoints that keep your awning hinge moving freely.

Quick answer

Replace the hinge pin and bush as a pair, not one at a time. The bush is what keeps the pin centered and the hinge moving smoothly, so reusing a worn bush with a new pin usually shortens the life of both.

Why the bush matters as much as the pin

A hinge pin carries the load, but the bush controls how that load is spread. If the bush is ovalized or cracked, a new pin will rattle and wear quickly. That is why a set of two is useful: you have a matching pair for the hinge and a spare for the next repair.

This is also why you should inspect the hinge arms and brackets before ordering. If the arm itself is bent or the mounting plate is cracked, a new pin and bush will not fix the movement. In that case, the hinge repair becomes a larger parts replacement.

When to replace rather than tighten

Tightening a loose hinge can mask a worn bush for a short time, but it does not restore the fit. If the awning arm wobbles at the hinge, or if you can see play between the pin and the surrounding material, replacement is the better path. If the hinge is simply stiff, clean and lubricate first; do not force a pin out of a corroded hinge.

Step-by-step hinge pin and bush replacement

Identify the correct hinge and part: Compare your awning hinge to the parts diagram supplied with the Foxwing replacement parts listing. Confirm you are replacing the pin and bush at the hinge, not the mounting assembly or arm pivot. If the diagram does not match your hinge, stop and confirm the part before removing anything.
Support the awning arm before removal: Open the awning only as far as needed to access the hinge, and have a second person hold the arm or support it with a prop. The arm can drop once the pin is out. Never let the arm hang on the remaining hinge while you work.
Drive out the old pin: Use a punch or drift that is slightly smaller than the pin and tap evenly from one side. Work over a tray so the pin and any washers do not disappear into the ground. If the pin will not move, apply penetrating oil and wait rather than hitting harder.
Remove and inspect the old bush: Push or pry the old bush out of the hinge eye and check the bore for scoring, oval wear, or corrosion. Clean the bore before fitting the new bush. A scored bore will chew through a new bush; address the surface first.
Fit the new bush and pin: Seat the new bush squarely in the hinge eye, align the hinge halves, and slide the new pin through. Fit any washers in the order you removed them. The pin should pass through by hand or with light taps; stop if it binds.
Check movement and secure the pin: Open and close the awning through its full range and watch for binding or side play. Secure the pin with its retaining clip or fastener, then recheck. If the hinge still wobbles, the bore or arm is worn and needs further inspection.

Product facts

Foxwing Replacement Parts - Foxwing Hinge Pin/Bush (Set of 2): The Foxwing Hinge Pin/Bush set includes two pieces and is listed as an easy fix for a broken Foxwing part. Having a matching pair means you can replace both sides of the hinge in one session and keep a spare for the next wear interval.
Foxwing Replacement Parts - Foxwing Hinge Pin/Bush (Set of 2)