Identifying the Broken Part
If your Foxwing awning's pole end cap has come loose or the rivet has snapped, you likely need to replace the rivet and washer assembly. The Foxwing Replacement Parts - Pole End Cap Rivet and Pole End Cap Washer (Pack of 8) is the correct kit for this fix. Before ordering, confirm that the damaged part is indeed the rivet/washer combo and not another component like the end cap itself or the hinge pin.
The kit includes 8 sets, so you have spares for future repairs or for multiple awnings. The catalog describes it as "an easy fix" and instructs you to "determine the part that needs replacing in the above diagram, order it and it will be at your door as soon as possible!" – meaning the diagram on the product page is your first diagnostic tool.
Product Facts
- Foxwing Replacement Parts - Pole End Cap Rivet and Pole End Cap Washer (Pack of 8): Pack of 8 pole end cap rivet and washer sets for Foxwing awnings. You get multiple replacements in one kit, so you can fix one awning and still have spares.
Foxwing Replacement Parts - Pole End Cap Rivet and Pole End Cap Washer (Pack of 8) - Foxwing Replacement Parts - Pole End Cap Rivet and Pole End Cap Washer (Pack of 8): Catalog description: 'AN EASY FIX. Determine the part that needs replacing in the above diagram, order it and it will be at your door as soon as possible!' The manufacturer expects this to be a straightforward repair, and the diagram helps you confirm you're ordering the right piece.
How to Replace the Pole End Cap Rivet and Washer
The supplied evidence does not include step-by-step installation instructions, but the following general procedure is typical for this type of repair. Use caution and refer to any diagrams included with your kit.
- Remove the damaged rivet: Use a small punch and hammer to drive out the broken rivet from the pole end cap. If the washer is still attached, remove it as well. Work on a stable surface and wear eye protection.
- Insert the new washer and rivet: Place the new washer over the rivet hole, then insert the new rivet through the washer and into the end cap. Ensure the rivet is seated squarely.
- Set the rivet: Use a rivet tool (not included) to pull and set the rivet. Apply steady pressure until the mandrel snaps. Check that the end cap is now firmly attached to the pole.
- Test the repair: Open and close the awning arm to confirm the end cap stays in place and the pole moves freely. If the rivet loosens again, you may need a different part or a more thorough inspection.
What to Do If the Rivet Kit Doesn't Fit
The Foxwing uses several different end cap designs depending on the model year and awning size. If the rivet and washer from this kit do not match your existing hardware, double-check the diagram on the product page. The catalog states that you should "determine the part that needs replacing in the above diagram" – so the diagram is essential for correct identification. If you still have doubts, contact Oztent USA support with a photo of your damaged part.
